Maintenance and Repair Hurst eDraulic tools and Eagle Breath Compressor

For Market Research Only.

Scope: This order provides for maintenance and repair service of Eagle Air compressor and HURST Hurst eDraulic tools equipment.

The following request represents the minimum requirements of the Joint Region Marianas Fire and Emergency Services.

Description:
Provide Routine annual service for Eagle breathing air compressor.
MN: B4A15M3D5U
SN: 25618301
Includes:
- Routine maintenance parts
- Purification cartridge
- Air filter
- Oil
- Air Sample

Scope of work compressor service
1. Inspect oil level/pressure
2. Inspect air pressure gauges
3. Calibrate CO Monitor/moisture Indicator
4. Change purification filters
5. Change O-rings
6. Service Auto-drain
7. Lubricate motor/engine
8. Inspect on-off button/emergency stop
9. Inspect fill whips
10. Inspect muffler, reservoir and drain
11. Inspect regulators
12. Inspect doors, panels, and frame
13. Inspect piping fittings and monitor for air leaks
14. Insure head bolts at proper torque
15. Inspect and clean cooling fans
16. Service Final Separator
17. Clean compressor
18. Air sample (optional, but recommended)
19. Inspect compressor and fill system for air leaks
20. Inspect and replace air/intake filter
21. Inspect and clean compressor coolers
22. Inspect drive belts
23. Check and record inter-stage pressure readings

Perform routine annual service on Hurst eDraulic tools. 17 units
-Replace eDraulic fluid on all Hurst tools
-Provide the following part to be used for repair.
-4 EA 272085888S HURST S700 2.0 Blade and Plate Kit OEM
-1 EA 172080119S HURST Pivot Bolt OEM
-2 EA 172085108S HURST S700 2.0 Guards - Plugs and Hardware OEM
-1 EA 172085110S HURST S700 2.0 Handle Kit OEM
-1 EA 172090016S HURST Handle for Edraulic Combi-Tool OEM
-2 EA 172080366S HURST Gen 1 Edraulic Shuttle Valve OEM
-8 EA 172085324S HURST Check Valve Set for E2 Series Tools

Scope of Work - Hurst eDraulic tools
Spreader / Cutter / Combi-tool
a. Visual inspection of tool
b. Inspect arms/tips/blades for wear & damage
c. Inspect shaft seal & piston rod
d. Inspect control valve
e. Operate tool and observe speeds
f. Remove pivot pins, link arms and blades; clean & lube
g. Replace decals as required
h. Torque main bolt to spec

Rams
a. Visual inspection of tool
b. Operate tool and observe speeds
c. Inspect shaft seal and piston
d. Check lights for proper operation
e. Replace decals as required
f. Inspect ram extension kit

Accessories
Batteries, Chargers, Adapters
a. Inspect case for cracking
b. Check lights for proper operation

Period of Performance of Service: To be determined upon award of contract

Service Location: Joint Region Marianas Fire & Emergency Services