Calibration and Metrology Services   2

This is a modification (no. 6) to the synopsis entitled Calibration and Metrology Services (CAMS) IV which was posted on May 22, 2020. Please see below:

THIS IS NOT A REQUEST FOR PROPOSAL. NO PROPOSALS ARE TO BE SUBMITTED IN RESPONSE TO THIS NOTICE.

This notice is issued by the NASA/JSC to post a draft RFP to solicit responses from interested parties. This document is for information and planning purposes and to allow industry the opportunity to verify reasonableness and feasibility of the requirement, as well as promote competition.

The principal purpose of CAMS IV is to operate and maintain JSC's Metrology Standards and Calibration Laboratory (MSCL) located in Building 343 at JSC. The NASA JSC in Houston, TX currently has an existing Metrology Standards and Calibration Laboratory (MSCL) located in Building 343. The MSCL provides calibration operations for Measurement and Test Equipment (MTE) primarily for JSC Organizations. The MSCL also supports calibrations for other NASA centers and Federal Government Agencies. Most MTE are commercial off-the shelf used to measure physical, mechanical, and electrical properties such as torque wrenches, pressure transducers, and voltmeters.

This presolicitation synopsis is not to be construed as a commitment by the Government, nor will the Government pay for the information submitted in response. The Government may not respond to questions/concerns submitted. The Government will use the information to finalize the RFP as necessary.

All comments or questions shall be submitted electronically via email to Kelsey Klinger at kelsey.j.klinger@nasa.gov and Sam Mcilvoy at samuel.p.mcilvoy@nasa.gov, no later than November 25th, 2020 at 5:00PM Central Time. When responding reference 80JSC020CAMSIV.

NASA Clause 1852.215-84, Ombudsman, is applicable. The Center Ombudsman for this acquisition can be found at http://prod.nais.nasa.gov/pub/pub_library/Omb.html .

If a solicitation is released, then it and any additional documents will be available on www.beta.sam.gov. It is the offeror's responsibility to monitor this website for the release of the solicitation and amendments (if any). Potential offerors will be responsible for downloading their own copy of the solicitation and amendments, if any.